## pyprofibus hardware documentation

pyprofibus can run on about anything that has a serial port.

However some hardware is superior to other. See the documentation below for the various hardware alternatives and its characteristics.

## pyprofibus on Linux with /dev/ttyS0 or /dev/ttyAMA0 serial port

Using the Linux serial port is a supported way to connect pyprofibus to a Profibus network. On some boards it may only supports low baud rates of up to about 19200 baud. However that depends on the actual serial transceiver hardware. On certain embedded boards with flexible serial hardware, high baudrates such as 1.5 MBaud may also be possible.

To run pyprofibus on serial port configure pyprofibus as follows:

    [PHY]
    type=serial
    dev=/dev/ttyS0
    baud=19200

## pyprofibus on Linux with /dev/ttyUSB0 serial port

It is not recommended to run pyprofibus on an emulated USB serial adapter. USB does not meet the realtime requirements of Profibus. It might work with slow baud rates, though. Use without any guarantee.

## pyprofibus on ESP32 with Micropython

Pyprofibus on ESP32 with Micropython supports baud rates of at least 1.5 MBaud.

Please see the pyprofibus Micropython help.

To run pyprofibus on Micropython serial port (UART 2) configure pyprofibus as follows:

    [PHY]
    type=serial
    dev=UART2
    baud=1500000

## pyprofibus on Linux with FPGA PHY

This is one of the fastest albeit most expensive alternative to connect pyprofibus to a Profibus network. Currently baud rates of up to 1.5 MBaud are supported. There is room for improvement towards higher baud rates.

The pyprofibus FPGA is connected via high speed SPI bus to the host computer. It’s known to work well with the Raspberry Pi. However it’s not strictly limited to that as host computer. The pyprofibus FPGA PHY driver utilizes the Linux SPI subsystem for communication to the FPGA board.

Please see the pyprofibus FPGA PHY documentation for more information on how to build and run the FPGA PHY.

To run pyprofibus on FPGA PHY configure pyprofibus as follows:

    [PHY]
    type=fpga
    spiBus=0
    spiCS=0
    spiSpeedHz=2500000
    baud=1500000

The FPGA PHY is currently not supported on Micropython.

## pyprofibus on MS Windows

pyprofibus has been reported to work on Windows with the serial PHY. Just use the COM1 / COM2 / COMx as dev= in the configuration. The same restrictions apply as with Linux serial PHY. Please the the Linux /dev/ttyS0 section.